6/15 Compression Gas Springs
MK Gas Springs manufactures 6/15 compression gas springs with a 6 mm piston rod and a 15 mm cylinder. These gas springs provide a pushing force to assist lifting and support moving components such as lids, hatches and covers.
Configure the dimensions, force and end fittings to suit your application. Check the available combinations in the configurator to select a configuration that matches your requirements.
6/15 Gas Spring Specifications
The extended length (Lex) range of 75–500 mm shown in the table excludes end fittings and threads. With end fittings at both ends, Lex is measured between their mounting centres. With one end fitting, Lex is measured from its mounting centre to the shoulder at the opposite threaded end, excluding the exposed thread.
S is the visible piston rod length in the unloaded position, excluding the thread or end fitting. The working stroke (Sw) is the maximum available travel and may be shorter than S.
The configurator shows the available combinations of dimensions and force, together with the applicable working stroke.
| Parameter |
Specification |
|---|---|
| Gas spring type |
Compression (push type) |
| Piston rod diameter (Ød) |
6 mm |
| Cylinder diameter (ØD) |
15 mm |
| Piston rod end thread |
M6 |
| Cylinder end thread |
M6 |
| Force range |
40–400 N |
| Visible piston rod length (S) |
20–225 mm |
| Extended length without end fittings (Lex) |
75–500 mm |
Configure Your 6/15 Compression Gas Spring
Request a Quotation
Confirm your configuration, then complete the form below to request a quotation. Configuration images are attached automatically.
© 2026 MK Material Oto. San. ve Tic. Ltd. Şti.
Manufacturer and supplier of gas springs and fastening components. Operating internationally since 2016, backed by over 20 years of industry experience.
CONTACT
I.O.S.B. Eskoop. San. Sit. C6 Blok No: 291
Başakşehir / Istanbul / TÜRKİYE
MK MATERIAL
Gas Springs & End Fittings